Shingles
Roof shingles are roof covering that consist of individual overlapping elements. These elements are typically flat, rectangular shapes laid in courses from the bottom edge of the roof up, with each successive course overlapping the joints below. Shingles are held by the roof rafters and are made of various materials such as wood, slate, flagstone, metal, plastic, and composite materials such as fiber cement and asphalt shingles.
Leak On Shingle Roof
Missing shingles, hail damage, or old shingles can cause a leaking roof this can be noticeable by water stains on the ceiling. Our inspector will first look at any visible damage on the roof (missing shingle or hail damage )but if an obvious soft spot on the ceiling is observed we will inspect the damage and will give you the most efficient solution to fix the problem.
Flat Roof
A flat roof is a roof that is mostly level in contrast to the many types of sloped roofs. The slope of a roof is properly known as its pitch and flat roofs have up to approximately 10°.
Flat Roof Leaks
When a leak occurs on a flat roof, damage often goes unnoticed for a considerable time as water penetrates and soaks the decking and any insulation and/or structure beneath. This often leads to expensive damage from the rot which often develops and if left can weaken the roof structure. Health risks exist to people and animals breathing the mold spores: this health risk can be range from mild to severe. If the problem is detected early enough, the insulation may be saved by repairing the leak, but if it has progressed to creating a sunken area, it may be too late. We are here to help you keep your roof and health at its best.
TPO Roof
TPO, or thermoplastic polyolefin, is one of the many types of synthetic rubber products available to homeowners and businesses alike. TPO is a waterproof, UV-resistant plastic sheeting that can be used in a variety of ways. From water collection and drainage to waterproofing and insulation, there are many applications for this material. We can offer a wide range of applications depending on what will be more efficient for your roof.
TPO Leaks
One of the most common TPO roof leaks is caused by penetration into the membrane. TPO is a membrane and can be easily penetrated with any sharp object such as a nail or knife. When it rains, the water will travel inside through the hole and run underneath the membrane until it finds a way through the building inside.
EPDM Roof
EPDM is an extremely durable synthetic rubber roofing membrane (ethylene propylene diene terpolymer) widely used in low-slope buildings in the United States and worldwide. Its two primary ingredients, ethylene, and propylene are derived from oil and natural gas. EPDM is available in both black and white and is sold in a broad variety of widths. EPDM can be installed either fully adhered, mechanically attached, or ballasted, with the seams of the roofing system sealed with liquid adhesives or specially formulated tape.
EPDM Leaks
Leaks in EPDM roofs can happen for several reasons, including punctures in, or damage to, the membrane, shrinkage, incorrectly installed or improper flashing, wrinkles extending into roof seams.
The best way to deal with roof leaks is through prevention, rather than cure, as usually, once you’ve noticed a leak, the chances are it’s already done some damage. This is where regular roof inspections and clearing debris away from the roof come in.
Remember that the source of the leak may not be directly above where the damp patch has come through. Water can run in any number of directions, so it’s important to thoroughly inspect the roof space.
If the source of the leak is found, it’s important to determine the full scope of the problem, as if moisture has already got through your EPDM membrane, and it gets trapped, it can cause bubbling and blistering as well as potentially lead to rot. So, it’s more than just fixing the original leak!
Fixes may include re-laying the entire roof, or part of the membrane, applying a patch, or re-installing the flashing. It will depend on the issue at hand. If you think you might have a leak, call us for a free estimate.
Gutters
Rain gutters come in six materials and are two common shapes. Select between the k-style gutter and the half-round gutter. Here are the basic gutter parts and how they work together:
Gutters catch the rainwater.
Downspouts bring the water down and away from the house.
Elbows change a downspout’s direction.
Brackets secure the gutter system to the house or building.